LTP Crackle Glaze Protector 500ml

For interior use only: For ceramic tiles that have a porous crackle glaze and for use on the tile and grout joints. This product helps to protect tiles from penetration by water, dirt, oil, grease, limescale and other household contaminants. 

Directions for use: Ensure that the tile surface is clean and dry. Any tiles that are wet cut should be protected with at least one coat of sealer. Once the tiles have been fixed and before grouting, apply at least one coat of the sealer with a sponge or soft cloth, but then buff immediately into the surface using the LTP Buffing Cloth. This should be done until all excess is removed. Leave for a minimum of 2 hours before grouting with normal grouts.

If coloured or pigmented grouts are to be used: Apply at least a further three coats and do not buff off the excess. Allow 2 hours between each coat. Grout in the joints and remove excess immediately using a sponge and water. Leave grout to harden (approximately 2 hours). Use LTP Grout Stain Remover and LTP Black Course Pad to de-bond remaining grout residue and sealer. Wipe off remaining residue with LTP Buffing Cloth.

Optional: Once dry (minimum 24 hours), apply a further coat of sealer to the surface also covering the joints. After 48 hours the surface can be cleaned as normal. Use LTP Buffing Cloth to remove any excess from non-absorbent surfaces.

Drying time: Approximately 30-40 minutes. Becomes fully effective after approximately 48 hours.