LTP Grout and Tile Protector 600ml

Tiles Direct

Product ID: 6930

Rs.14.99
RRP Rs.19.99
|
You save up to 25 %

Item in Stock | Usually dispatched within 2-3 working days

Colour: Clear

Size (ml): 600ml

Approximate Coverage: 600 linear meters, depending upon the size of the grout joint and number of coats required. 5-25m2 of tile and grout, depending on the porosity and the number of coats required.

Suitability: Use as a 'top coat' to protect from penetration by water, dirt, oil, grease and limescale, making treated surfaces easier to clean. Ideal for use in wetrooms and shower enclosures.

You can use the LTP Coverage Calculator to confirm how much you will need of this product.

The Technical Data sheet can be found here.

NOTE: Do not use harsh abrasive cleaning agents. Clean treated areas with water and a mild PH neutral detergent like LTP Waxwash or LTP Stonewash. In some instances, it may be necessary to use a stronger cleaner to remove stubborn surface marks, in which case you may need to reseal treated areas.

Do not spray on to acrylic or stained surfaces such as cabinets and stained timber skirting boards. Mask and protect these surfaces before application.

Interior and Exterior use: Forms a colourless barrier and helps to protect porous wall and floor grout joints from penetration by water, dirt, oil, grease and limescale, making treated surfaces easier to keep clean.

Ideal for use in wetrooms and shower enclosures. Used as a 'top coat', this product is an easy way to further protect natural stone and all other types of masonry surfaces. Overspray on most surfaces will completely dissipate and not leave any hard-to-remove residue.

When sealing a porous stone, it is advisable to use a suitable liquid impregnator such as LTP Mattstone or LTP Colour Intensifier before finishing with LTP Grout and Tile Protector to achieve the best result.

Directions for use: Areas to be treated must be cleaned. Older contaminated and dirty grouting should be cleaned with LTP Grimex and then rinsed thoroughly. Newly grouted sirfaces should be left to cure for about 20-30 minutes and should be clean and free from dust before application. Always test the product on an inconspicuous area for suitability before general application.

Shake can well. Spray 15-20cm from the surface and spray in a sweeping motion. Touch dry within 5 minutes. a 2-3 hour curing ti8ime is recommended upon completion before allowing traffic.

For wet areas (including shower enclosures and werooms): allow the sealer to cure for a minimum of 24 hours before use. Test area after application with a little water. If the water is absorbed, a second or even third coat may be required to obtain maximum performance.

Only use in open or well-ventilated areas. Open windows and if possible, use fans to circulate the air. It is recommended that a suitable respiratory mask be worn at all times.

Overspray on highly polished porcelain or stone and highly glazed surfaces may in some cases leave a slight residue, in which case, wipe up any excess within 5 minutes. Stubborn residues left on the surface can be removed with the application of more LTP Grout and Tile Protector which should then be buffed off immediately.