Mapei Kerapoxy 111 Silver Grout Grout 5kg

Tiles Direct

Product ID: 14000

Rs.54.99
RRP
|
You save up to %

Item in Stock | Usually dispatched within 2-3 working days

Colour: Silver Grey

Size (kg): 5kg

Approximate coverage: 5-7m2

Suitability: Indoor and outdoor grouting of ceramic tile and natural stone floors and walls. Also suitable for acid-resistant bonding and rapid setting of ceramic tiles, stone materials, fibre-cement, concrete and any other building material on all types of substrates normally used for construction.

Colour-matched silicone available under product ID 6907

You can use the Mapei Coverage Calculator to confirm how much you will need of this product.

The Technical Data sheet for this item can also be found here

Features:

Excellent mechanical and chemical resistance
Smooth final surface with low water absorption - easy to clean and hygienic
Easy workability and finish
Becomes very hard and is highly resistant to heavy traffic
No shrinkage
Uniform colours that are resistant to ultra-violet rays and atmospheric agents
Excellent bonding

Preparation of the joints: Joints must be dry, clean, free of dust and emptied at least 2/3 of the tile thickness. Excess adhesive or mortar should be removed while still fresh. Before grouting, make sure that the installation mortar or the adhesive has set and released most of its moisture.

Preparation of the mix: Pour the hardener (component B) into the container of component A and mix well until a smooth paste is obtained. For perfect mixing and avoiding overheating of the mixture, which could reduce working time, a low-speed electric should be used. Use the mix within 45 minutes of preparation.

Application: Spread Kerapoxy over the tiled surface with an appropriate rubber float, making sure the joints are completely filled. Use the same float, but on the edge, to remove excess grout.

Finishing: After grouting, floor finishes should be cleaned immediately before the product dries. Wet the surface thoroughly and emulsify with an abrasive pad for cleaning joints, making sure not to wash-out the joints. When cleaning walls, the cleaning pad should be fully soaked with water. The excess liquid can be removed with a hard cellulose sponge and should be replaced when it is too full of resin.